Operating Hour Notification System: Reset confirmation signal

Related KB links

• Reset Operating Hour Counter (Mechanical Wire Type)

  Procedure · 1. Stop the engine. 2. Set the gearshift at F or R. 3. Turn the ignition switch ON. The buzzer will sound once. 4. Put in and pull out the emergency stop switch clip 5 times within 20 seconds. WARNING: The buzzer will...

• Water separator buzzer sounds (rapid, repeating signal)

  Diagnostic · Cause: Water contamination in the water separator Test: Check the water separator for water presence; if water is present, stop the engine and clean the water separator (see page 100)

• Operating Hour Notification System: Emergency stop switch clip cycles to reset hour counter

  Spec · 5 conditions={"timeWindow":"within 20 seconds"}

• Reset Operating Hour Counter (DBW Type)

  Procedure · 1. Stop the engine. 2. Turn the ignition switch or power switch ON. 3. Set the gearshift at F or R. 4. Put in and pull out the emergency stop switch clip 5 times within 20 seconds. WARNING: The buzzer will sound once ...

• Water separator buzzer sounds a rapid, repeating signal

  Diagnostic · Cause: Water has accumulated in the water separator Test: Inspect and drain the water separator