Specification
Transom mounting bolts: Mounting bolt diameter
12.7 mm conditions={"imperial_equivalent":"1/2 in."}
Specification
12.7 mm conditions={"imperial_equivalent":"1/2 in."}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Do not install wedges or plates between the transom clamp brackets and the transom (or jack plate). WARNING: Installing wedges or plates between the transom clamp brackets and the transom or jack plate is prohibite...
Diagnostic · Cause: Boat transom construction is inadequate to handle outboard mounting loads Test: Apply 75 Nm (55 lb-ft) torque to mounting locknut/bolt and inspect transom for cracking or deformation Expected: No cracking or yi...
Spec · 0.125 in conditions={}
Procedure · 1. Check the decal on the transom bracket reminding you to verify fasteners securing the outboard to the transom before each use. WARNING: Failure to correctly fasten the outboard could result in the outboard propelli...
Diagnostic · Cause: Boat transom is yielding under bolt torque; transom construction may not be adequate Test: Apply 75 Nm (55 lb-ft) torque to mounting locknut/bolt using a dial torque wrench and observe dial reading Expected: To...