Manual Tilt RC Type - Tilt Down

Related KB links

• Power Trim and Tilt unit: Air Purging Cycle Count

  Spec · 5–6 times conditions={"procedure":"Tilt outboard motor manually up/down with manual release valve set to Manual side"}

• Poor tilting movement and increased noise from Power Tilt unit

  Diagnostic · Cause: Entrapped air in the Power Tilt unit Test: Perform air purging procedure: set manual release valve to Manual, tilt motor up/down 5–6 times manually, then close valve to Power side

• Manual relief valve: Manual relief valve tightening torque

  Spec · 2 N·m conditions={"also":"1.5 ft·lb, 0.2 kgf·m"}

• Manual Tilt RC Type - Tilt Up

  Procedure · 1. Put the control lever to the Forward (F) position. WARNING: Ensure control lever is in Forward (F) position before tilting. 2. Tilt the outboard motor all the way up until it is in the tilted-up position. 3. Set th...

• Engine overheating during shallow water operation

  Diagnostic · Cause: Outboard motor tilted too high, causing air to be sucked through the water inlet Test: Check that the cooling water intake (water inlet) remains fully submerged during shallow water drive