Procedure
1. Stop the engine. 2. Shift into neutral position. 3. Tilt up the outboard motor. 4. Lock the tilt stopper. 5. Change the trim lock pin position as shown in the picture: (1) Trim lock pin, (2) Higher, (3) Lower.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · -5 to 6 degree conditions={"transom_angle":"-12°"}
Diagnostic · Cause: Trim angle set too low Test: Observe hull attitude relative to water surface while underway Expected: Hull horizontal; anti-ventilation plate parallel to water surface
Spec · 61 degree conditions={"transom_angle":"-12°"}
Procedure · 1. Stop the engine. 2. Operate the Power Tilt switch and raise the outboard motor to the tilt-up position. 3. Lock the tilt with the Tilt stopper. 4. Change the trim lock pin position: move pin to a higher hole to inc...
Diagnostic · Cause: Entrapped air in the Power Tilt unit Test: Perform air purging procedure: set manual release valve to Manual, tilt motor up/down 5–6 times manually, then close valve to Power side