Diagnostic
Overheat indicator (RED) comes on and buzzer sounds a steady tone
Cause: Engine overheating detected; engine speed reduced to 1,800 rpm Test: Check for clogged water intakes; monitor cooling system indicator for water flow
Diagnostic
Cause: Engine overheating detected; engine speed reduced to 1,800 rpm Test: Check for clogged water intakes; monitor cooling system indicator for water flow
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 20 seconds conditions={"trigger":"Overheat indicator activates and engine speed limited"}
Procedure · 1. During the warm-up period, check the oil pressure indicator (p. 49), overheat indicator (p. 49), and cooling system indicator (p. 50). WARNING: If the indicators show any abnormal condition, immediately stop the en...
Spec · 1800 rpm conditions={"trigger":"Overheat indicator activated"}
Procedure · 1. Above 41°F (5°C): Allow the engine to warm up for 2 to 3 minutes before getting underway. 2. Below 41°F (5°C): Raise the fast idle lever to achieve approximately 2,000 rpm and warm up the engine for at least 10 min...
Diagnostic · Cause: Engine was not sufficiently warmed up before raising engine speed Test: Check warm-up duration and fast idle lever position prior to throttle increase