Procedure
Engine oil filler cap installation after oil service
1. Install the oil filler cap and tighten it securely. Do not overtighten. WARNING: Do not overtighten the oil filler cap. 2. Install and lock the engine cover (refer to p. 88).
Procedure
1. Install the oil filler cap and tighten it securely. Do not overtighten. WARNING: Do not overtighten the oil filler cap. 2. Install and lock the engine cover (refer to p. 88).
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · Lights again after engine starts and stays lit to indicate normal oil pressure conditions={"event":"After engine start"}
Diagnostic · Cause: Operating engine with oil level below LOWER LIMIT mark on dipstick Test: Remove dipstick, wipe clean, reinsert fully, remove and verify oil level is between LOWER and UPPER LIMIT marks
Spec · 8.2 US qt conditions={"filterChange":"Yes","also":"7.8 L"}
Procedure · 1. Unlock and remove the engine cover. WARNING: Drain the used oil while the engine is warm. Warm oil drains quickly and completely. 2. Place a suitable container below the oil drain guide to catch the used oil, then ...
Diagnostic · Cause: Engine oil overfilled beyond upper limit mark on dipstick Test: Check dipstick oil level; confirm oil is not above UPPER LIMIT mark