Specification
Cylinder: Engine oil per cylinder (storage fogging)
1–2 teaspoons (5–10 cm³) conditions={"context":"Storage preparation — fogging oil application"}
Specification
1–2 teaspoons (5–10 cm³) conditions={"context":"Storage preparation — fogging oil application"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Change the engine oil and the oil filter (see pp. 91–93). 2. Remove the spark plugs (see p. 95) and remove the emergency stop switch clip from the emergency stop switch. 3. Pour 1–2 teaspoons (5–10 cm³) of clean en...
Diagnostic · Cause: Engine oil becomes less efficient as a lubricant due to water or fuel contamination from low-RPM or short-run operation cycles
Spec · 3,000 rpm conditions={"note":"Running below 3,000 rpm for more than 30% of operating time leads to water condensation and unburned fuel mixing with engine oil"}
Procedure · 1. Check the outboard motor as described in the BEFORE OPERATION chapter of the manual. 2. Start the engine. If the cylinders were coated with oil during storage preparation, the engine may smoke briefly at startup. T...
Diagnostic · Cause: Operating engine with oil level below LOWER LIMIT mark on dipstick Test: Remove dipstick, wipe clean, reinsert fully, remove and verify oil level is between LOWER and UPPER LIMIT marks