Procedure
Changing Engine Oil - Oil Changing Procedure
1. Tilt the outboard out/up past vertical for approximately one minute to allow any trapped oil to drain back to the oil sump.
Procedure
1. Tilt the outboard out/up past vertical for approximately one minute to allow any trapped oil to drain back to the oil sump.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · Within cross-hatched region between bottom bar and top bar conditions={"note":"Do not attempt to fill to the top of the operating range; oil is correct as long as it appears anywhere within the cross-hatched region"}
Diagnostic · Cause: Insufficient engine oil Test: Check engine oil level per Fuel and Oil – Checking and Adding Engine Oil procedure
Spec · Mercury or Quicksilver SAE 25W-40 Synthetic Blend Marine 4-Stroke Engine Oil conditions={"use":"Optional choice"}
Procedure · 1. Before starting (cold engine), tilt outboard out/up past vertical to allow trapped oil to drain back to the oil sump. Allow outboard to remain tilted for approximately one minute. WARNING: Do not overfill. Check oi...
Diagnostic · Cause: Low oil pressure — check oil level