Procedure
1. Install the propeller onto the shaft with the supplied components as shown in the diagram. 2. Place the locknut retainer over the raised pins on the drive sleeve adapter and tighten the locknut to the specified torque.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 2-4-C with PTFE conditions={"partNumber":"92-802859A 1","tubeRefNo":"95"}
Diagnostic · Cause: Exhaust gas mixing with water over the propeller blades due to worn, loose, or damaged propeller bore sleeve Test: Inspect propeller bore sleeve when propeller is removed; check for wear, looseness, or broken r...
Spec · 75 Nm conditions={"lb-ft":"55.3"}
Procedure · 1. Install the propeller onto the shaft with the supplied components as shown, including the forward thrust washer (a), drive sleeve (b), propeller (c), drive sleeve adapter (d), locknut retainer (e), and locknut (f)....
Diagnostic · Cause: Cable barrel adjustment too close to the cable end Test: Shift remote control into reverse while turning propeller and check if propeller shaft locks Expected: Propeller shaft locked in gear