Procedure
Reset Engine Guardian Protection after overspeed rev limit activation
1. Completely reduce the throttle and hold for three seconds. 2. Engage the throttle. If the engine does not respond, repeat step 1.
Procedure
1. Completely reduce the throttle and hold for three seconds. 2. Engage the throttle. If the engine does not respond, repeat step 1.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 6 seconds conditions={"trigger":"Critical sensor fault detected"}
Diagnostic · Cause: Engine RPM at or exceeding overspeed limit set in PCM Test: Monitor RPM against specification; no audible warning during overspeed limit activation
Spec · 1500–2000 RPM conditions={"operation":"Outboard above trim range"}
Procedure · 1. Reduce engine speed immediately upon Engine Guardian activation. WARNING: The problem must be identified and corrected before Engine Guardian will allow the engine to reach normal operating RPM. 2. Move the throttl...
Diagnostic · Cause: Critical sensor fault detected by Engine Guardian system Test: Reduce engine speed; identify and correct fault; reset by moving throttle lever back to idle position