Procedure
1. Ensure the outboard is upright (not tilted) and the engine is cold or has not run for at least one hour, to reduce or prevent oil spillage when removing the oil filter. WARNING: To reduce or prevent oil spillage when removing the oil filter, ensure the outboard is upright (not tilted) and the engine is cold or has not run for at least one hour. 2. Remove the top cowl. 3. Place a rag or towel below the oil filter to absorb any spilled oil.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 3/4 to 1 turn after gasket contacts base conditions={"note":"Tighten after gasket contacts mounting base"}
Diagnostic · Cause: Lanyard too short or improperly routed, causing premature switch activation Test: Check lanyard routing; if lanyard is too short, do not shorten further — ensure at-rest coiled length is not taut while operator...
Spec · Clean oil film only — do not use grease
Procedure · 1. Tilt outboard out/up past vertical for approximately one minute to allow trapped oil to drain back to the oil sump. WARNING: Ensure the outboard is tilted out/up past vertical for at least one minute before proceed...
Diagnostic · Cause: Water in the fuel filter has reached the full level Test: Visually inspect fuel filter holder for water accumulation