Procedure
3. Unscrew old filter using oil filter wrench, turning the filter counterclockwise. 4. Clean the oil filter mounting base. 5. Apply a film of clean oil to filter gasket. Do not use grease. 6. Screw new filter on until gasket contacts base, then tighten 3/4 to 1 turn. Tools: Oil Filter Wrench 91‑802653Q02 Parts: Oil Filter Wrench (91‑802653Q02)
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 3/4 to 1 turn after gasket contacts base conditions={"note":"Tighten after gasket contacts mounting base"}
Diagnostic · Cause: Lanyard too short or improperly routed, causing premature switch activation Test: Check lanyard routing; if lanyard is too short, do not shorten further — ensure at-rest coiled length is not taut while operator...
Spec · 6.0 liter (6.3 US qt) liter conditions={"includes":"oil filter replacement"}
Procedure · 1. Position filter holder onto bracket and secure filter holder in place. 2. Lubricate the sealing ring on the filter with oil. 3. Install the filter and tighten securely by hand. 4. Visually inspect for fuel leakage ...
Diagnostic · Cause: Water in the fuel filter has reached the full level Test: Visually inspect fuel filter holder for water accumulation