Specification
Engine: Break-in Phase 1 max RPM
4500 RPM conditions={"phase":"First 2 hours","throttle":"up to 4500 RPM or three-quarter throttle, full throttle ~1 min every 10 min"}
Specification
4500 RPM conditions={"phase":"First 2 hours","throttle":"up to 4500 RPM or three-quarter throttle, full throttle ~1 min every 10 min"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. For the first two hours of operation, run the engine at varied throttle settings up to 4500 RPM or at three-quarter throttle, and at full throttle for approximately one minute every ten minutes. WARNING: Failure to...
Diagnostic · Cause: Engine operated at RPM greater than or equal to the overspeed rev limit Test: 1. Completely reduce throttle for three seconds. 2. Engage throttle. If engine does not respond, repeat step one.
Spec · 5 minutes conditions={"phase":"Next 8 hours"}
Procedure · 1. Reduce engine speed below 2000 RPM. 2. Tilt the outboard up. Make sure all water intake holes stay submerged at all times. 3. Operate the engine at slow speed only. If engine speed exceeds 2000 RPM, the outboard wi...
Diagnostic · Cause: Propeller pitch too low or diameter inappropriate for load Test: Check full throttle RPM under normal load condition