Engine: Break-in Phase 2 max continuous full-throttle duration

Related KB links

• Engine Break-in Procedure

  Procedure · 1. For the first two hours of operation, run the engine at varied throttle settings up to 4500 RPM or at three-quarter throttle, and at full throttle for approximately one minute every ten minutes. WARNING: Failure to...

• Critical - Continuous six-second beep from warning horn

  Diagnostic · Cause: Critical engine condition detected; Engine Guardian system may engage and limit power Test: Key engine to ON and listen for horn signal pattern

• Engine: Break-in Phase 2 duration

  Spec · 8 hours conditions={"phase":"Phase 2","restriction":"Avoid continuous full throttle for more than 5 minutes at a time"}

• Tilting to Full Up Position – Tilt at Helm

  Procedure · 1. If the ignition key switch has been turned off for over 15 minutes, turn it to the ON position. 2. Press the trim/tilt switch to the up position. The outboard will tilt up until the switch is released or it reaches...

• Engine: Break-in Phase 1 full-throttle interval

  Spec · ~1 minute every 10 minutes conditions={"phase":"First 2 hours"}