Specification
Engine: Break-in Phase 1 full-throttle interval
~1 minute every 10 minutes conditions={"phase":"First 2 hours"}
Specification
~1 minute every 10 minutes conditions={"phase":"First 2 hours"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. For the first two hours of operation, run the engine at varied throttle settings up to 4500 RPM or at three-quarter throttle, and at full throttle for approximately one minute every ten minutes. WARNING: Failure to...
Spec · 5 minutes conditions={"phase":"Next 8 hours"}
Procedure · 1. Remove the oil fill cap and add recommended oil to the midpoint of the operating range (midpoint of cross hatched region). Adding approximately 6 liter (6.3 US qt) will bring oil level to midpoint of cross hatched ...
Spec · 2 hours conditions={"phase":"Phase 1"}
Procedure · 1. Remove the flush connector from the bottom cowl. 2. Remove the cover from the flush connector and thread a water hose into the flush connector. 3. Turn on the water tap (1/2 maximum) and let the water flush through...