Specification
Engine: Shallow Water Operation - Max Engine Speed (Tilted)
2000 RPM conditions={"mode":"Shallow water operation","note":"If engine speed exceeds 2000 RPM, outboard will automatically return down to maximum trim range"}
Specification
2000 RPM conditions={"mode":"Shallow water operation","note":"If engine speed exceeds 2000 RPM, outboard will automatically return down to maximum trim range"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Reduce engine speed below 2000 RPM. 2. Tilt the outboard up. Make sure all water intake holes stay submerged at all times. 3. Operate the engine at slow speed only. If engine speed exceeds 2000 RPM, the outboard wi...
Diagnostic · Cause: Engine operated at RPM greater than or equal to the overspeed rev limit Test: 1. Completely reduce throttle for three seconds. 2. Engage throttle. If engine does not respond, repeat step one.
Spec · below 2000 RPM conditions={"mode":"Shallow water operation","note":"Reduce engine speed below 2000 RPM before tilting outboard up"}
Procedure · 1. Use the Trim Control (handle) [Item a] to raise or lower the engines for best efficiency or for conditions such as shallow water or trailering. 2. Observe NEUTRAL lights [Item b]: they illuminate when the drive is ...
Diagnostic · Cause: Outboard trimmed out too far, raising cooling water intake holes above the waterline Test: Verify cooling water intake holes are below waterline at current trim angle