Specification
Flywheel Cover Screw: Flywheel cover subassembly screw torque
6 Nm conditions={"lb_in":"53"}
Specification
6 Nm conditions={"lb_in":"53"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Install the upper half of the flywheel cover subassembly to the lower flywheel cover subassembly. Ensure the upper flywheel cover latch opening is properly secured to the lower flywheel cover. 2. Push the two subas...
Diagnostic · Cause: Reduced air density due to high elevation, high temperature, low barometric pressure, or high humidity — cannot be compensated by engine fuel or electronic management systems Test: Verify operating conditions; ...
Spec · 53 lb-in
Procedure · 1. Secure the flywheel cover to the rear mounting posts with two bolts with washers. (torque: 10 Nm) Parts: Flywheel cover bolt and washer
Diagnostic · Cause: Boat transom construction is inadequate to handle outboard mounting loads Test: Apply 75 Nm (55 lb-ft) torque to mounting locknut/bolt and inspect transom for cracking or deformation Expected: No cracking or yi...