Procedure
Flywheel Cover Installation
1. Secure the flywheel cover to the rear mounting posts with two bolts with washers. (torque: 10 Nm) Parts: Flywheel cover bolt and washer
Procedure
1. Secure the flywheel cover to the rear mounting posts with two bolts with washers. (torque: 10 Nm) Parts: Flywheel cover bolt and washer
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 10 Nm conditions={"also_lb_in":"88.5"}
Diagnostic · Cause: Reduced air density due to high elevation, high temperature, low barometric pressure, or high humidity — cannot be compensated by engine fuel or electronic management systems Test: Verify operating conditions; ...
Spec · 53 lb-in
Procedure · 1. Install the upper half of the flywheel cover subassembly to the lower flywheel cover subassembly. Ensure the upper flywheel cover latch opening is properly secured to the lower flywheel cover. 2. Push the two subas...
Diagnostic · Cause: Shift actuator failure Test: Turn ignition key switch off to reset and then start the engine