Diagnostic
Engine Starts But Will Not Shift Into Gear
Cause: Shift actuator failure Test: Turn ignition key switch off to reset and then start the engine
Diagnostic
Cause: Shift actuator failure Test: Turn ignition key switch off to reset and then start the engine
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 2000 RPM conditions={"mode":"Shallow water operation","note":"If engine speed exceeds 2000 RPM, outboard will automatically return down to maximum trim range"}
Procedure · 1. Place the ERC lever in neutral. 2. Press the 'Throttle-Only' button. The button light will turn on and the neutral lights will blink.
Spec · 650 RPM conditions={"note":"With engine fully warmed up"}
Procedure · 1. Place either ERC lever into gear. The warning horn will beep each time the lever is moved in and out of gear while in throttle-only mode, but the engine will remain in neutral. 2. Increase RPM of the engines as nee...
Diagnostic · Cause: Throttle only mode is engaged