Specification
Flywheel cover bolt: Flywheel cover bolt torque
10 Nm conditions={"also_lb_in":"88.5"}
Specification
10 Nm conditions={"also_lb_in":"88.5"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Secure the flywheel cover to the rear mounting posts with two bolts with washers. (torque: 10 Nm) Parts: Flywheel cover bolt and washer
Diagnostic · Cause: Boat transom construction is inadequate to handle outboard mounting loads Test: Apply 75 Nm (55 lb-ft) torque to mounting locknut/bolt and inspect transom for cracking or deformation Expected: No cracking or yi...
Spec · 6 Nm conditions={"lb_in":"53"}
Procedure · 1. Install the upper half of the flywheel cover subassembly to the lower flywheel cover subassembly. Ensure the upper flywheel cover latch opening is properly secured to the lower flywheel cover. 2. Push the two subas...
Diagnostic · Cause: Boat transom is yielding under bolt torque; transom construction may not be adequate Test: Apply 75 Nm (55 lb-ft) torque to mounting locknut/bolt using a dial torque wrench and observe dial reading Expected: To...