Injector power and boost valve (INJ. PWR.): Injector power and boost valve fuse rating

Related KB links

• Water Separating Fuel Filter Removal

  Procedure · 1. Turn ignition key switch to the OFF position. 2. Remove the fuel vapor purge relief valve cap located at the rear of the engine to release fuel system pressure. WARNING: Failure to release pressure from the fuel sy...

• Loss of engine power

  Diagnostic · Cause: High elevation (over 8,000 ft) causing over 30% power loss, or hot and humid conditions causing up to 14% power loss

• Electronic Control Module and purge valve (ECM): ECM fuse rating

  Spec · 20 amp

• Checking Power Trim Fluid

  Procedure · 1. Tilt the outboard to the full up position and engage the tilt support lever. 2. Remove the fill cap and check the fluid level. The fluid level should be even with the bottom of the fill hole. Add Quicksilver or Mer...

• Non-critical - Intermittent short beeps for six seconds from warning horn

  Diagnostic · Cause: Non-critical engine condition detected; Engine Guardian system may limit power Test: Key engine to ON and listen for horn signal pattern