Procedure
1. Close the air vent screw on the fuel tank cap. WARNING: Failure to close the vent may result in fuel leakage. 2. Disconnect the fuel connector between the engine and the fuel tank. 3. Disconnect the battery cord after each use.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 10 cm (4 in.) conditions={"context":"To avoid overheating of the engine"}
Diagnostic · Cause: Fuel tank overfilled; air vent screw loose or open under high temperature conditions Test: Check fill level does not exceed tank capacity; ensure air vent screw is closed during transport/storage
Spec · Oil level must reach the bottom line of the plug hole conditions={"motorPosition":"Tilted up and locked with tilt stopper","tankPosition":"Vertical"}
Procedure · 1. Put the control lever in the Neutral position and run the engine for 2–3 minutes at idling speed for cooling down if it has been running at full speed. 2. Turn the main switch key to the OFF position or push the st...
Diagnostic · Cause: Entrapped air in the Power Tilt unit Test: Perform air purging procedure: set manual release valve to Manual, tilt motor up/down 5–6 times manually, then close valve to Power side