Procedure
Procedure extracted from numbered steps
1. Apply sealing agent, such as silicone 2. Be sure to tighten the mounting bolt 3. Shift cable 4. Throttle cable 5. Cable harness B 6. Remote control device
Procedure
1. Apply sealing agent, such as silicone 2. Be sure to tighten the mounting bolt 3. Shift cable 4. Throttle cable 5. Cable harness B 6. Remote control device
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · Direct trim tab toward B (right from rear of boat) conditions={"location":"Under anti-ventilation plate"}
Diagnostic · Cause: Entrapped air in the Power Tilt unit Test: Perform air purging procedure: set manual release valve to Manual, tilt motor up/down 5–6 times manually, then close valve to Power side
Spec · Direct trim tab toward A (left from rear of boat) conditions={"location":"Under anti-ventilation plate"}
Procedure · 1. Install the stop switch lock to the stop switch, and attach the stop switch lanyard securely to the operator or to the operator's PFD (Personal Flotation Device). WARNING: Always secure the lanyard to the operator ...
Diagnostic · Cause: Internal pressure of fuel tank raised by heat from sources such as sunlight; cap loosened using incorrect procedure. Test: Inspect fuel tank cap opening procedure; ensure correct procedure is followed.