Specification
Outboard motor mounting: Anti-ventilation plate position below hull bottom (maximum)
25 mm conditions={"reference":"Bottom of hull"}
Specification
25 mm conditions={"reference":"Bottom of hull"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Verify the boat's certification plate and ensure the outboard motor horsepower does not exceed the maximum allowable horsepower rating shown on the plate. WARNING: Do not equip your boat with an outboard motor that...
Diagnostic · Cause: Trim angle set too low Test: Observe hull attitude relative to water surface while underway Expected: Hull horizontal; anti-ventilation plate parallel to water surface
Spec · 1 in conditions={"reference":"Bottom of hull"}
Procedure · 1. Verify the boat's certification plate for maximum allowable horsepower; do not equip the boat with an outboard motor exceeding this limit. WARNING: Mounting an outboard motor that exceeds the boat's rated horsepowe...
Diagnostic · Cause: Trim angle set too high Test: Observe hull attitude relative to water surface while underway Expected: Hull horizontal; anti-ventilation plate parallel to water surface