Specification
BF250D: Trim Angle
-4° to 16° degrees conditions={"transomAngle":"12°"}
Specification
-4° to 16° degrees conditions={"transomAngle":"12°"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Use the power trim/tilt switch (UP or DN side) to adjust the angle of the outboard motor. The switch can be used whether the boat is underway or stopped. 2. Refer to the trim meter (p. 44) for an indication of whet...
Diagnostic · Cause: Load in the front of the boat, or outboard motor trimmed too low Test: Observe boat attitude at speed; check trim angle and load distribution
Spec · –4° to 16° conditions={"transomAngle":"12°"}
Procedure · 1. Use the power trim/tilt switch (see pages 75–76) to tilt the outboard motor up so the propeller and gear case clear the bottom. 2. Proceed at low speed. 3. Monitor water flow from the cooling system indicator (see ...
Diagnostic · Cause: Load in the rear of the boat, or outboard motor trimmed too high Test: Observe boat attitude at speed; check trim angle and load distribution