Specification
Engine: Break-in Phase 2 max RPM
2000–3000 rpm conditions={"phase":"Next 45 minutes","throttle_opening":"10%–30% of maximum","max_rpm_time_limit":"50% of the 45-minute period"}
Specification
2000–3000 rpm conditions={"phase":"Next 45 minutes","throttle_opening":"10%–30% of maximum","max_rpm_time_limit":"50% of the 45-minute period"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Run the engine at trolling speed for the first 15 minutes. Use the minimum throttle opening necessary to operate the boat at a safe trolling speed. WARNING: Avoid continuous operation at a steady speed throughout t...
Diagnostic · Cause: Unburned fuel mixing with the oil, caused by running the engine below 3,000 rpm for more than 30% of the time or frequent starting and stopping without allowing the engine to warm up Test: Check oil level on di...
Spec · 4000–5000 rpm conditions={"phase":"Next 60 minutes","throttle_opening":"50%–80% of maximum","max_rpm_time_limit":"50% of the 60-minute period"}
Procedure · 1. Turn the ignition switch key to the ON position. The buzzer will sound twice to confirm. 2. Turn the ignition switch key to the START position and hold it there until the engine starts. WARNING: Do not operate the ...
Diagnostic · Cause: Water condensation in the engine mixing with oil, caused by running the engine below 3,000 rpm for more than 30% of the time or frequent starting and stopping without allowing the engine to warm up Test: Inspec...