Specification
Propeller Castle Nut: Castle Nut Initial Tightening Torque
0.7 lbf·ft conditions={"stage":"Initial snug","equivalentSI":"1.0 N·m","equivalentMetric":"0.1 kgf·m"}
Specification
0.7 lbf·ft conditions={"stage":"Initial snug","equivalentSI":"1.0 N·m","equivalentMetric":"0.1 kgf·m"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Remove the emergency stop switch clip from the emergency stop switch to prevent accidental engine start. WARNING: The propeller blades may have sharp edges; wear heavy gloves to protect your hands. 2. Apply marine ...
Diagnostic · Cause: Overtightening of spark plugs Test: Verify spark plug torque does not exceed specified value (13 lbf·ft / 18 N·m) Expected: 13 lbf·ft
Spec · 33 lbf·ft conditions={"stage":"Final alignment to cotter pin hole","equivalentSI":"44 N·m","equivalentMetric":"4.5 kgf·m","note":"Do not exceed this limit or propeller and shaft may be damaged"}
Procedure · 1. Stop the engine and remove the engine cover (see p. 88). WARNING: Ensure the engine is fully stopped before removing the engine cover. 2. Confirm that there is no cooling water leakage from the engine. Tools: Castl...
Diagnostic · Cause: Trim tab not correctly adjusted; reaction of outboard motor to propeller rotation Test: Test steering effort in both directions; adjust trim tab until effort is equal in both directions