Diagnostic
Engine overheating
Cause: Cooling water intake holes are above the waterline due to excessive trim-out
Diagnostic
Cause: Cooling water intake holes are above the waterline due to excessive trim-out
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 1 in conditions={"engine_state":"running at idle speed"}
Procedure · 1. Reduce the engine speed below 2000 RPM. WARNING: Operating the engine with the outboard in the tilt range can damage the engine or the transom. Do not exceed 2000 RPM. 2. Tilt the outboard up. Verify all of the coo...
Spec · 25.4 mm conditions={"engine_state":"running at idle speed"}
Procedure · 1. Reduce engine speed below 2000 RPM. 2. Tilt the outboard up. Make sure all water intake holes stay submerged at all times. WARNING: Ensure all water intake holes remain submerged at all times to prevent engine dama...
Diagnostic · Cause: Excessive water in bilge