Diagnostic
Cause: Shift cable barrel position too far from cable end Test: Shift remote control into forward and check if propeller shaft is locked in gear Expected: Propeller shaft locked in gear
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 22 in conditions={"note":"For heights over this value, a propeller designed for surfacing operation is usually preferred"}
Procedure · 1. Make a center mark 'c,' midway between marks 'a' and 'b.' Align the cable end guide against this center mark when installing the cable to the engine. 2. Position the remote control into neutral. 3. Place the barrel...
Spec · 56.0 cm conditions={"note":"For heights over this value, a propeller designed for surfacing operation is usually preferred"}
Procedure · 1. Shift remote control into reverse while turning propeller. The propeller shaft should be locked in gear. WARNING: If propeller shaft is not locked in gear, adjust the barrel away from the cable end. Repeat steps a ...
Diagnostic · Cause: Cable barrel adjustment too close to the cable end Test: Shift remote control into reverse while turning propeller and check if propeller shaft locks Expected: Propeller shaft locked in gear