Procedure
1. Shift remote control into reverse while turning propeller. The propeller shaft should be locked in gear. WARNING: If propeller shaft is not locked in gear, adjust the barrel away from the cable end. Repeat steps a through c. 2. Shift remote control back to neutral. The propeller shaft should turn freely without drag. WARNING: If propeller shaft does not turn freely without drag, adjust the barrel closer to the cable end. Repeat steps a through d.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 50/50 conditions={"application":"When water marks cannot be removed with a damp cloth"}
Diagnostic · Cause: Cable barrel adjustment too close to the cable end Test: Shift remote control into reverse while turning propeller and check if propeller shaft locks Expected: Propeller shaft locked in gear
Spec · 15 amp
Procedure · 1. Make a center mark 'c,' midway between marks 'a' and 'b.' Align the cable end guide against this center mark when installing the cable to the engine. 2. Position the remote control into neutral. 3. Place the barrel...
Diagnostic · Cause: Cable barrel adjustment too far from the cable end Test: Shift remote control to neutral and check if propeller shaft turns freely Expected: Propeller shaft turns freely without drag