Diagnostic
Cause: Cable barrel adjustment too far from the cable end Test: Shift remote control to neutral and check if propeller shaft turns freely Expected: Propeller shaft turns freely without drag
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 2000 RPM conditions={"operation":"Shallow water tilt mode","note":"If engine speed exceeds 2000 RPM, outboard will automatically return down to maximum trim range"}
Procedure · 1. Shift remote control into reverse while turning propeller. The propeller shaft should be locked in gear. WARNING: If propeller shaft is not locked in gear, adjust the barrel away from the cable end. Repeat steps a ...
Spec · 75 Nm conditions={"note":"Transom must not yield or crack under this torque; if it does, transom must be strengthened or load carrying area increased","equivalent_imperial":"55 lb-ft"}
Procedure · 1. Make a center mark 'c,' midway between marks 'a' and 'b.' Align the cable end guide against this center mark when installing the cable to the engine. 2. Position the remote control into neutral. 3. Place the barrel...
Diagnostic · Cause: Shift cable barrel position too close to cable end Test: Shift remote control into neutral and check if propeller shaft turns freely without drag Expected: Propeller shaft turns freely without drag