Specification
Engine / Power Trim System: Shallow water operation max engine speed
2000 RPM conditions={"operation":"Shallow water tilt mode","note":"If engine speed exceeds 2000 RPM, outboard will automatically return down to maximum trim range"}
Specification
2000 RPM conditions={"operation":"Shallow water tilt mode","note":"If engine speed exceeds 2000 RPM, outboard will automatically return down to maximum trim range"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Reduce engine speed below 2000 RPM. 2. Tilt the outboard up. Make sure all water intake holes stay submerged at all times. WARNING: Ensure all water intake holes remain submerged at all times to prevent engine dama...
Diagnostic · Cause: Cooling water intake holes are above the waterline due to excessive trim-out
Spec · 2000 RPM conditions={"operation":"Outboard in tilt range"}
Procedure · 1. Reduce the engine speed below 2000 RPM. WARNING: Operating the engine with the outboard in the tilt range can damage the engine or the transom. Do not exceed 2000 RPM. 2. Tilt the outboard up. Verify all of the coo...
Diagnostic · Cause: Blown 15 amp fuse — check 14 pin remote control harness/cowl trim switch/main power relay fuse