Diagnostic
Starter Motor Will Not Crank the Engine
Cause: Blown 15 amp fuse — check 14 pin remote control harness/cowl trim switch/main power relay fuse
Diagnostic
Cause: Blown 15 amp fuse — check 14 pin remote control harness/cowl trim switch/main power relay fuse
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 2000 RPM conditions={"operation":"Shallow water tilt mode","note":"If engine speed exceeds 2000 RPM, outboard will automatically return down to maximum trim range"}
Procedure · 1. Verify the engine is in a level vertical position. 2. Verify the vessel fuel supply line is connected to the outboard fuel system inlet fitting. 3. Turn the ignition key on. The fuel pumps will run for approximatel...
Spec · 15 amp
Procedure · 1. Shift the outboard to the neutral (N) position. 2. Turn the ignition key to the START position and release the key. The electronic starting system will automatically crank the engine for starting. 3. If the engine ...
Diagnostic · Cause: Wiring or electrical connection faulty