Starter Motor Will Not Crank the Engine

Related KB links

• Starter Motor: Starter motor cool-down period between crank events

  Spec · 20–30 seconds conditions={"event":"FSM priming – ran out of fuel condition"}

• Pre-use lanyard stop switch and cord inspection

  Procedure · 1. Start the engine and pull the lanyard cord to verify the lanyard stop switch stops the engine. If the engine does not stop, have the switch repaired before operating the boat. WARNING: Do not operate the boat if th...

• Starter Motor / Electronic Starting System: Maximum crank duration per start attempt (fuel fill procedure)

  Spec · 8 seconds conditions={"condition":"Initial start or fuel system empty"}

• Priming the FSM (Ran out of Fuel Condition) – Without Purge Tool

  Procedure · 1. Verify the engine is in a level vertical position. 2. Verify the vessel fuel supply line is connected to the outboard fuel system inlet fitting. 3. Turn the ignition key on. The fuel pumps will run for approximatel...

• Starter Motor Will Not Crank the Engine

  Diagnostic · Cause: Ignition key switch failure