Procedure
Drill Mounting Holes
1. Drill four 13.5 mm (17/32 in.) mounting holes. Tools: Drill, 13.5 mm (17/32 in.) drill bit
Procedure
1. Drill four 13.5 mm (17/32 in.) mounting holes. Tools: Drill, 13.5 mm (17/32 in.) drill bit
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 13.5 mm (17/32 in.) conditions={"quantity":"4"}
Diagnostic · Cause: Non-flat or stepped transom mounting surface exceeding 3.17 mm (0.125 in.) tolerance
Spec · 12.7 mm (1/2 in.) conditions={"quantity":"4 bolts","configuration":"Two bolts through upper set of holes, two bolts through lower set of holes"}
Procedure · 1. Before drilling any mounting holes, carefully read Determining Recommended Outboard Mounting Height and install outboard to the nearest recommended mounting height. WARNING: IMPORTANT: Do not skip the mounting heig...
Diagnostic · Cause: Outboard mounted too high on transom — exceeds maximum mounting height for model Test: Measure mounting height: must not exceed 63.5 cm (25 in.) for L models or 76 cm (30 in.) for XL models