Procedure
1. Remove the top cowl. 2. Install the lifting base to the flywheel using three bolts. Tighten the bolts securely. 3. Thread the lifting eye into the lifting base. 4. Connect a hoist that has a minimum lift capacity of 450 kg (1000 lb) to the lifting eye. WARNING: Hoist must have a minimum lift capacity of 450 kg (1000 lb). 5. Lift the outboard and place it on the transom. Tools: Lifting base, Lifting eye, Hoist (minimum 450 kg / 1000 lb capacity)
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 75 Nm conditions={"note":"Transom must not yield or crack under this torque; if it does, transom must be strengthened or load carrying area increased","equivalent_imperial":"55 lb-ft"}
Diagnostic · Cause: Exhaust gas mixing with water over the propeller blades due to worn, loose, or damaged propeller bore sleeve Test: Inspect propeller bore sleeve when propeller is removed; check for wear, looseness, or broken r...
Spec · 450 kg (1000 lb) conditions={"application":"Outboard Lifting"}
Procedure · 1. Apply marine sealer to the shank of the outboard mounting bolts (not the threads). WARNING: Do not apply marine sealer to the bolt threads. 2. Install 0.500 in. diameter outboard mounting bolts (x4) with 0.875 in. ...
Diagnostic · Cause: Outboard mounted too high on transom — exceeds maximum mounting height for model Test: Measure mounting height: must not exceed 63.5 cm (25 in.) for L models or 76 cm (30 in.) for XL models