Procedure
Operating in Shallow Water
1. When operating in shallow water, tilt the outboard beyond the maximum trim range to minimize possible contact with the bottom.
Procedure
1. When operating in shallow water, tilt the outboard beyond the maximum trim range to minimize possible contact with the bottom.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 2000 RPM conditions={"operation":"Shallow water tilt mode","note":"If engine speed exceeds 2000 RPM, outboard will automatically return down to maximum trim range"}
Diagnostic · Cause: Excessive trim-in causing the bow to plow through water while on plane
Spec · 2000 RPM conditions={"operation":"Outboard in tilt range"}
Procedure · 1. Reduce the engine speed below 2000 RPM. WARNING: Operating the engine with the outboard in the tilt range can damage the engine or the transom. Do not exceed 2000 RPM. 2. Tilt the outboard up. Verify all of the coo...
Diagnostic · Cause: Outboard trimmed so propeller shaft is not parallel to the water surface Test: Observe trim angle and adjust to neutral steering condition