Procedure
1. Secure the locknut by bending three of the tabs into the grooves in the drive sleeve adapter. (torque: 75 Nm) WARNING: Ensure three tabs are fully bent into the grooves to prevent locknut from backing off. Parts: Forward thrust washer, Drive sleeve, Propeller, Drive sleeve adapter, Locknut retainer, Locknut
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 75 Nm conditions={"also_lb_ft":"55.3"}
Diagnostic · Cause: Exhaust gas mixing with water over the propeller blades due to worn, loose, or damaged propeller bore sleeve Test: Inspect propeller bore sleeve when propeller is removed; check for wear, looseness, or broken r...
Spec · 75 Nm conditions={"lb-ft":"55.3"}
Procedure · 1. Install the propeller onto the shaft with the supplied components as shown, including the forward thrust washer (a), drive sleeve (b), propeller (c), drive sleeve adapter (d), locknut retainer (e), and locknut (f)....
Diagnostic · Cause: Cable barrel adjustment too close to the cable end Test: Shift remote control into reverse while turning propeller and check if propeller shaft locks Expected: Propeller shaft locked in gear