Specification
Propeller nut: Propeller nut torque
75 Nm conditions={"also_lb_ft":"55.3"}
Specification
75 Nm conditions={"also_lb_ft":"55.3"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Install the propeller onto the shaft with the supplied components as shown, including the forward thrust washer (a), drive sleeve (b), propeller (c), drive sleeve adapter (d), locknut retainer (e), and locknut (f)....
Diagnostic · Cause: Outboard trimmed so propeller shaft is not parallel to the water surface Test: Observe trim angle and adjust to neutral steering condition
Spec · 75 Nm conditions={"lb-ft":"55.3"}
Procedure · 1. Secure the locknut by bending three of the tabs into the grooves in the drive sleeve adapter. (torque: 75 Nm) WARNING: Ensure three tabs are fully bent into the grooves to prevent locknut from backing off. Parts: F...
Diagnostic · Cause: Shift cable barrel position too far from cable end Test: Shift remote control into forward and check if propeller shaft is locked in gear Expected: Propeller shaft locked in gear