Procedure
1. Turn the ignition key on. When the fuel pumps stop running, start the engine. 2. If the engine does not start on the first attempt, retry. The engine will run rough at idle for up to two minutes while residual air is purged from the fuel system.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · up to 2 minutes conditions={"event":"Post-prime startup"}
Diagnostic · Cause: Fuel system not primed (e.g., new engine, ran out of fuel, or fuel was drained) Test: Turn ignition to ON for ~5 seconds, then turn to START and release; engine cranks up to 8 seconds. Repeat until engine remai...
Spec · 20–30 seconds conditions={"event":"FSM priming – ran out of fuel condition"}
Procedure · 1. Verify the engine is in a level vertical position. 2. Verify the vessel fuel supply line is connected to the outboard fuel system inlet fitting. 3. Turn the ignition key on. The fuel pumps will run for approximatel...
Diagnostic · Cause: Incorrect starting procedure — refer to Operation section