Procedure
1. Rotate the steering wheel to fully retract the steering cable end into the outboard tilt tube. 2. Lubricate the steering cable grease fitting (if equipped) with 2-4-C with PTFE or Extreme Grease through the fitting. Parts: 2-4-C with PTFE (92-802859A 1), Extreme Grease (8M0071842)
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 2-4-C with PTFE or Extreme Grease conditions={"partNumbers":"92-802859A 1 / 8M0071842","tubeRefNo":"95"}
Diagnostic · Cause: Outboard trimmed so propeller shaft is not parallel to the water surface Test: Observe trim angle and adjust to neutral steering condition
Spec · Tighten until it seats, then back off 1/4 turn conditions={"application":"Steering link rod to steering cable assembly"}
Procedure · 1. Completely retract the end of the steering cable before applying lubricant to avoid hydraulic lock. WARNING: Incorrect cable lubrication can cause hydraulic lock, leading to serious injury or death from loss of boa...
Diagnostic · Cause: Excessive trim-in causing the bow to plow through water while on plane