Specification
Engine: Break-in period Phase 1 max RPM
4500 RPM conditions={"duration":"First 2 hours","throttle":"Varied, up to 4500 RPM or three-quarter throttle; full throttle ~1 min every 10 min"}
Specification
4500 RPM conditions={"duration":"First 2 hours","throttle":"Varied, up to 4500 RPM or three-quarter throttle; full throttle ~1 min every 10 min"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. For the first two hours of operation, run the engine at varied throttle settings up to 4500 RPM or at three-quarter throttle, and at full throttle for approximately one minute every ten minutes. WARNING: Failure to...
Diagnostic · Cause: Restricted fuel flow due to added components (filters, valves, fittings, etc.) in the fuel supply system Test: Inspect fuel supply system for any added restrictive components
Spec · 5 minutes conditions={"duration":"Next 8 hours"}
Procedure · 1. Switch to a lower pitch propeller. 2. Change the gear ratio if available. 3. Prop the engine to allow it to operate at or near the top end of the recommended maximum RPM range at wide-open throttle with a normal bo...
Diagnostic · Cause: Engine RPM at or exceeding overspeed limit set in PCM Test: Monitor RPM against specification; no audible warning during overspeed limit activation