Specification
Engine: Break-in period Phase 2 max continuous full-throttle duration
5 minutes conditions={"duration":"Next 8 hours"}
Specification
5 minutes conditions={"duration":"Next 8 hours"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. For the first two hours of operation, run the engine at varied throttle settings up to 4500 RPM or at three-quarter throttle, and at full throttle for approximately one minute every ten minutes. WARNING: Failure to...
Diagnostic · Cause: Critical engine condition detected by Engine Guardian system Test: Return to port immediately; have servicing dealer inspect engine
Spec · 4500 RPM conditions={"duration":"First 2 hours","throttle":"Varied, up to 4500 RPM or three-quarter throttle; full throttle ~1 min every 10 min"}
Procedure · 1. With the engine turned off, place the outboard in either the operating position (vertical) or in a tilted position. 2. Remove the flush connector from the bottom cowl. 3. Remove the cover from the flush connector a...
Diagnostic · Cause: Outboard mounted too high on transom — exceeds maximum mounting height for model Test: Measure mounting height: must not exceed 63.5 cm (25 in.) for L models or 76 cm (30 in.) for XL models