Specification
Fuel System: Ignition ON duration before cranking (fuel fill procedure)
5 seconds conditions={"condition":"Initial start or fuel system empty"}
Specification
5 seconds conditions={"condition":"Initial start or fuel system empty"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Verify the engine is in a level vertical position. 2. Verify the vessel fuel supply line is connected to the outboard fuel system inlet fitting. 3. Turn the ignition key on. The fuel pumps will run for approximatel...
Diagnostic · Cause: Fuel system not primed (e.g., new engine, ran out of fuel, or fuel was drained) Test: Turn ignition to ON for ~5 seconds, then turn to START and release; engine cranks up to 8 seconds. Repeat until engine remai...
Spec · 8 seconds conditions={"condition":"Initial start or fuel system empty"}
Procedure · 1. Shift the outboard to the neutral (N) position. 2. Turn the ignition key to the START position and release the key. The electronic starting system will automatically crank the engine for starting. 3. If the engine ...
Diagnostic · Cause: Improper reassembly or damaged fuel system component Test: Visual inspection of all serviced fuel system connections and components before starting the engine