Specification
Outboard mounting bolt: Outboard mounting bolt diameter
0.500 in conditions={"quantity":"4"}
Specification
0.500 in conditions={"quantity":"4"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Use supplied outboard transom mounting hardware: mounting bolt (½-20 x 4.50 in., Part No. 67755-1), nylon insert locknut (½-20, Part No. 826711-17), flat washer 1.50 in. dia. (Part No. 28421), and flat washer 0.875...
Diagnostic · Cause: Aftermarket accessories (e.g., boarding ladders, shallow water anchors, transom wedge kits, tow sport devices) mounted using the same fasteners that secure the outboard to the transom or jack plate, compromisin...
Spec · 12.7 mm (1/2 in.) conditions={"quantity":"4 bolts","configuration":"Two bolts through upper set of holes, two bolts through lower set of holes"}
Procedure · 1. Apply marine sealer to the shank of the outboard mounting bolts (not the threads). WARNING: Do not apply marine sealer to the bolt threads. 2. Install 0.500 in. diameter outboard mounting bolts (x4) with 0.875 in. ...
Diagnostic · Cause: Outboard mounted too high on transom — exceeds maximum mounting height for model Test: Measure mounting height: must not exceed 63.5 cm (25 in.) for L models or 76 cm (30 in.) for XL models