Diagnostic
Cause: Lanyard stop switch not activated or lanyard not properly attached to operator's PFD or wrist Test: Verify lanyard is clipped to operator's PFD or wrist and lanyard element is fully inserted into stop switch
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 10 % conditions={"oxygenate":"Methanol or Ethanol","note":"Boat fuel system may not tolerate same percentage; consult boat manufacturer"}
Procedure · 1. Before each use, start the engine and stop it by pulling the lanyard cord to verify the stop switch works properly. WARNING: If the engine does not stop when the lanyard cord is pulled, have the switch repaired bef...
Spec · 2 minutes conditions={"phase":"First hour of operation"}
Procedure · 1. Insert the lanyard element (plug end) fully into the lanyard stop switch. 2. Attach the lanyard cord clip to the operator's PFD or wrist. 3. If a shorter lanyard is desired, wrap the lanyard around the operator's w...
Diagnostic · Cause: Faulty lanyard stop switch Test: Start the engine and stop it by pulling the lanyard cord; if the engine does not stop, the switch requires repair