Procedure
1. Warm up the engine for three minutes to allow the lubrication system to circulate and deliver oil to all moving parts. WARNING: Without sufficient cooling water, the engine, the water pump, and other components will overheat and suffer damage. Provide a sufficient supply of water to the water inlets during operation. 2. Check that cooling water is coming out of the water pump indicator hole (location 'a') during warm-up.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 3 minutes conditions={"phase":"Before operation"}
Diagnostic · Cause: Water or dirt in the fuel tank or fuel filter Test: Inspect and drain fuel tank; inspect fuel filter for water or dirt contamination
Spec · 1000 RPM conditions={"state":"After warming up","transmission":"In Neutral"}
Procedure · 1. Use a 1:25 oil/gasoline mixture in the first tank of fuel. WARNING: Failure to follow the engine break-in procedures can result in poor performance throughout the life of the engine and can cause engine damage. 2. ...
Diagnostic · Cause: Cooling water intake obstruction, water pump failure, or blockage in cooling system Test: Stop engine and check cooling water intake for obstruction