Procedure
1. Remove the water plug from the motor and install it in the flushing attachment (hose adapter). 2. Attach a hose to the flushing attachment. 3. Turn on the water and adjust the flow so water is exiting the water pump indicator hose. 4. Continue flushing the outboard for five minutes. 5. Turn off the water and remove the flushing attachment. Install the water plug.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 5 minutes
Diagnostic · Cause: Fuel flooding Test: Push in choke knob, wait 30 seconds, then continue cranking
Spec · Thermostat controlled
Procedure · 1. With the outboard still in the water, close the fuel shut-off valve or disconnect the remote fuel line (if equipped) and run the engine until it stops to drain fuel from the carburetor. Remove outboard from the boa...
Diagnostic · Cause: Improper installation of the outboard on the transom Test: Verify outboard is mounted per Mercury Marine validated fastener instructions and torque specifications