Procedure
1. Stop the engine and close the air vent screw. WARNING: Ensure the proper procedures are followed for transportation and storage of the outboard to avoid the possibility of oil leaks. 2. Close the fuel valve knob. Disconnect the fuel connector. 3. Remove the motor from the hull and completely drain the water from the gearcase.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · Thermostat controlled
Diagnostic · Cause: Faulty lanyard stop switch Test: Start the engine and stop it by pulling the lanyard cord; if the engine does not stop, the switch requires repair
Spec · 1:25 oil/gasoline ratio conditions={"phase":"First tank of fuel during break-in"}
Procedure · 1. With the outboard still in the water, close the fuel shut-off valve or disconnect the remote fuel line (if equipped) and run the engine until it stops to drain fuel from the carburetor. Remove outboard from the boa...
Diagnostic · Cause: Water or dirt in the fuel tank or fuel filter Test: Inspect and drain fuel tank; inspect fuel filter for water or dirt contamination