Diagnostic
Cooling system problem — water pressure or engine temperature fault (non-critical beep)
Cause: Obstruction in water intake holes in lower unit Test: Stop engine; inspect water intake holes in lower unit for obstruction
Diagnostic
Cause: Obstruction in water intake holes in lower unit Test: Stop engine; inspect water intake holes in lower unit for obstruction
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 1/2 maximum conditions={"procedure":"Cooling system flush"}
Procedure · 1. Recognize intermittent short beeps for six seconds as a non-critical engine condition. 2. Check for operator-correctable conditions: water in fuel filter, cooling system obstruction, or low engine oil level. 3. If ...
Spec · 10 % of tank volume conditions={"reason":"Fuel expands in volume as temperature rises; full tank can leak under pressure"}
Procedure · 1. After engine starts, check for a steady stream of water flowing out of the water pump indicator hole. 2. If no water is coming out of the water pump indicator hole, stop the engine immediately. WARNING: Operating t...
Diagnostic · Cause: Obstruction in cooling water intake, water pump failure, or blockage in cooling system Test: Check cooling water intake for obstruction after stopping engine